This week has seen a lot of fibreglass lay-up taking place, but I'll save those photos until next time. So in the mean time, here are a few photos showing how the exhaust is going to sit with the new stainless link pipe that has been made and awaits welding. When that's all solid and can support itself, I'll reposition the exhaust clamp bracket and design a new exhaust hanger.
You may also notice in the pictures the prototype of the rearsets. There are a few improvements that we'd like to make before we go ahead and use them, but the needle rollers on the brake & gear change lever give a pleasingly smooth motion and the 5 position adjustment give plenty of options. They even fit the standard bike too!
No comments:
Post a Comment